Meridian Nortel 1 Option 11C Mini Installation Manual page 119

Figure 24
Chassis bracket installed on the back of the chassis
3 Fasten the chassis bracket to the back of the chassis using the
four #8-32 machine screws supplied with the bracket kit. See
Figure 24.
Note: Make sure that the slot feature on the chassis bracket is at the
top of the chassis. Also, the two tabs on the chassis bracket must
extend past the bottom of the chassis.
Tabs
4 Lift the chassis into place so that the slot on the chassis bracket
engages the hook feature on the wall bracket.
Carefully lower the chassis until the hook on the wall bracket fits
securely into the slot on the chassis bracket.
5 Fasten the chassis in position.
Fasten the tabs, that extend past the bottom of the chassis, to the
plywood backboard. Use the two remaining #12 wood screws from the
bracket kit to fasten the tabs to the backboard. See Figure 25.
Chapter 9 — Installing the chassis
Slot feature.
The hook feature on
the wall bracket fits
into this slot.
Option 11C Mini
Page 119 of 332
Planning and Installation Guide