ZyXEL Communications VMG1312 Cli Reference Manual page 9

www.zyxel.com
Options for the stop command
adsl stop :
Options for the connection command
adsl connection [--up] [--down] [--loopback] [--reverb]
[--medley] [--noretrain] [--L3][--diagMode][--Lo]
[--tones <xmtStart xmtNum xmtMap rcvStart rcvNum rcvMap>]
[--normal][--freezeReverb][--freezeMedley]
--up :
Starts ADSL connection in normal mode
--down :
Puts ADSL PHY in idle mode
--loopback :
Puts ADSL PHY in ATM cell loopback mode. In this modem ADSL PHY will not try to establish
connection .
--reverb :
Puts ADSL PHY in test mode in which it only sends REVERB signal
--medley :
Puts ADSL PHY in test mode in which it only sends MEDLEY signal
--noretrain :
In this mode ADSL PHY will be trying to establish connection as in normal mode, but once the
connection is up it will not retrain even if the signal is lost.
--L3 :
Puts ADSL modem in L3 power state
--diagmode :
Puts modem in diagnostic test mode
--L0 :
Puts modem in L0 mode
--tones :
Specifies tones which can be used by ADSL PHY.
Tone ranges should be given separated by commas. For example, to select tones 0 to 100 and 200 to
300 use:
--tones 0-100,200-300 :
ZyXEL Confidential
9