ZyXEL Communications VMG1312 Cli Reference Manual page 102

www.zyxel.com
usage: wlctl phytable table_id offset width_of_table_element [table_element]
Set/get table element of a table with the given ID at the given offset
Note that table width supplied should be 8 or 16 or 32
table ID, table offset can not be negative
pavars Set/get temp PA parameters
usage: wlctl down
wlctl pavars pa2gw0a0=0x1 pa2gw1a0=0x2 pa2gw2a0=0x3 ...
wlctl pavars
wlctl up
erride the PA parameters after driver attach(srom read), before diver up These override values will be
propogated to HW when driver goes up PA parameters in one band range (2g, 5gl, 5g, 5gh) must all
present if one of them is specified in the command, otherwise it will be filled with 0
povars
Set/get temp power offset
usage: wlctl down
wlctl povars cck2gpo=0x1 ofdm2gpo=0x2 mcs2gpo=0x3 ...
wlctl povars
wlctl up
override the power offset after driver attach(srom read), before diver up These override values will be
propogated to HW when driver goes up power offsets in one band range (2g, 5gl, 5g, 5gh) must all present
if one of them is specified in the command, otherwise it will be filled with 0 cck(2g only), ofdm, and
mcs(0-7) for NPHY are supported
fem
Set temp fem2g/5g value
usage: wlctl fem (tssipos2g=0x1 extpagain2g=0x2 pdetrange2g=0x1 triso2g=0x1 antswctl2g=0)
(tssipos5g=0x1 extpagain5g=0x2 pdetrange5g=0x1 triso5g=0x1 antswctl5g=0)
antgain
Set temp ag0/1 value
usage: wlctl antgain ag0=0x1 ag1=0x2
maxpower
Set temp maxp2g(5g)a0(a1) value
usage: wlctl maxpower maxp2ga0=0x1 maxp2ga1=0x2 maxp5ga0=0xff maxp5ga1=0xff
maxp5gla0=0x3 maxp5gla1=0x4 maxp5gha0=0x5 maxp5gha1=0x6
phy_antsel
get/set antenna configuration
set: -1(AUTO), 0xAB(fixed antenna selection)
where A and B is the antenna numbers used for RF chain 1 and 0 respectively
query: <utx>[AUTO] <urx>[AUTO] <dtx>[AUTO] <drx>[AUTO]
ZyXEL Confidential
102