ZyXEL Communications VMG1312 Cli Reference Manual page 123

www.zyxel.com
Serial Number: S120Y48000039
ledctl
This option will be control the CPE LED on|off.
Example as below:
> sys ledctl WLAN 0
Wireless LED OFF
btt
This option will be control CPE Button status as "Reset Button Status"," WL Button Status"," WL EN
Button Status".
Example as below:
> sys btt show
Button Test Status '0'
Reset Button Status '0'
WL Button Status '0'
WL EN Button Status '-1'
wanset
This option will be setting the CPE WAN config as "<ip> <mask> <gateway>".
gphytest
This option can be test the CPE LAN Status as "<eth port0 ~ port3>".
Example as below:
> sys gphytest mod1
GPHY Test Start with Mode 1
mii (phy addr 0x4) register 0 is 0x0140
mii (phy addr 0x4) register 9 is 0x2300
mii (phy addr 0x1) register 0 is 0x0100
mii (phy addr 0x1) register 9 is 0x0000
mii (phy addr 0x2) register 0 is 0x0100
mii (phy addr 0x2) register 9 is 0x0000
mii (phy addr 0x3) register 0 is 0x0100
mii (phy addr 0x3) register 9 is 0x0000
mii (phy addr 0x18) register 0 is 0xffff
mii (phy addr 0x18) register 9 is 0xffff
> eth1 Link DOWN.
eth1 Link UP 10 mbps full duplex
usbtest
This option can be test the CPE USB Status.
ZyXEL Confidential
123