ZyXEL Communications VMG1312 Cli Reference Manual page 14

www.zyxel.com
adsl qlnmntr [--time] [--freq]
--time :
Sets the time in seconds for which QLN monitoring is to be done. If set to 0 , monitoring will be done
for ever.
--freq :
Sets the frequency in milli-seconds of QLN reporting.
At the end of monitoring time , the result is available in the QLN MIB info and can be seen using
adsl info --QLN :
Also, during the monitoring period the updated results is being updated in MIB and can be seen
every "--freq" milli-seconds.
Guidelines and description for inm command
adsl inm [--start <BB_THRESH 10*dB> <INMIATO> <INMIATS>] [--stop] [--show]
Starting INM
adsl inm --start <BB_THRESH 10*dB> <INMIATO> <INMIATS> :
Broadband Threshold value expressed as 10*dB (range [-361 to 120]), inter-arrival time offset
INMIATO (range [3-511]) and inter-arrival time step in log2 format INMIATS (range [0-7]) are the
required parameters to be specified in start command
Stopping impulse noise monitoring
adsl inm --stop :
Displaying INM configuration and results
adsl inm –show :
This will print inm state (Active/Not) , mode, configuration and results in the following format. The
actual Inter Arrival Time Step in IAT histogram is displayed as INMIATS
INM State:ACTIVE BB_THLD=-10.0dB
INMIATS=16
INMAME (BB Counter)= 8777
INPEQ1: 0
INPEQ2: 0
INPEQ3: 0
. . .
. . .
INPEQ17: 0
Inter Arrival Histogram:
[2-2]: 0
[3-18]: 0
. . .
ZyXEL Confidential
INM_INPEQ_MODE=0
14
INMCC=0 INMAITO=2