ZyXEL Communications VMG1312 Cli Reference Manual page 52

www.zyxel.com
PPP connection will be torn down when there is no
user data activity over the WAN interface for more than
this idle time period.
Default value: 30 minutes.
--pppipextension <disable|enable>
The PPP IP extension mode of a PPPoE or PPPoA interface.
This option is only applied to a PPPoE or PPPoA interface.
Valid values: disable or enable.
Default value: disable.
--ipaddr <wanipaddress> <wansubnetmask>
The WAN IP address and WAN subnet mask of a IPOE or IPoA interface.
This option should only be used for a IPOE or IPoA interface. PPPoE and PPPoA interface always
receives the IP address, submask and DNS addresses automatically from the ISP through the PPP
protocol. If this option is used and the dhcpclient value is "enable", DHCP client will be disabled on
this interface. In general principle, static configuration overwrites dynamically assigned data.
<wanipaddress> - the WAN IP address.
Valid values: any valid IP address.
<wansubnetmask> - the WAN subnet mask.
Valid values: 0.0.0.1 - 255.255.255.255.
--dhcpclient <enable|disable>
The DHCP client state of the IPOE interface. This option is only valid to a IPOE interface. DHCP
client is not supported over any other type of WAN interface.
Valid values: enable or disable.
Default value: enable.
Options for the wan delete (interface/service) command
Usage:
wan delete interface atm <port.vpi.vci>
wan delete interface ptm <port> --priority <normal|high|both>
wan delete service Layer3InterfaceName
Note: A WAN service need to be deleted first before a corresponding wan interface can be deleted.
Options for the show (interface) command
wan show [<port.vpi.vci>]
<port.vpi.vci>
port: port number of the VCC to add.
Valid values: 0.
vpi: VPI of the VCC to add.
ZyXEL Confidential
52