ZyXEL Communications VMG1312 Cli Reference Manual page 106

www.zyxel.com
obss_scan_params
set/get Overlapping BSS scan parameters
Usage: wlctl obss_scan a b c d e ...; where
a-Passive Dwell, {5-1000TU}, default = 100
b-Active Dwell, {10-1000TU}, default = 20
c-Width Trigger Scan Interval, {10-900sec}, default = 300
d-Passive Total per Channel, {200-10000TU}, default = 200
e-Active Total per Channel, {20-1000TU}, default = 20
f-Channel Transition Delay Factor, {5-100}, default = 5
g-Activity Threshold, {0-100%}, default = 25
keep_alive
Send specified "keep-alive" packet periodically.
Usage: wlctl keep_alive <period> <packet>
period: Re-transmission period in milli-seconds. 0 to disable packet transmits.
packet: Hex packet contents to transmit. The packet contents should include the entire ethernet
packet (ethernet header, IP header, UDP header, and UDP payload) specified in network byte
order.
e.g. Send keep alive packet every 30 seconds:
wlctl
0x0014a54b164f000f66f45b7e08004500001e000040004011c52a0a8830700a88302513c413c400
0a00000a0d
srchmem
g/set ucode srch engine memory
pkt_filter_add
Install a packet filter.
Usage: wlctl pkt_filter_add <id> <polarity> <type> <offset> <bitmask> <pattern>
id: Integer. User specified id.
type: 0 (Pattern matching filter).
offset: Integer. Offset within received packets to start matching.
polarity: Set to 1 to negate match result. 0 is default.
bitmask: Hex bitmask that indicates which bits of 'pattern' to match. Must be same
size as 'pattern'. Bit 0 of bitmask corresponds to bit 0 of pattern, etc.
If bit N of bitmask is 0, then do *not* match bit N of the pattern with
the received payload. If bit N of bitmask is 1, then perform match.
pattern: Hex pattern to match.
pkt_filter_clear_stats
Clear packet filter statistic counter values.
ZyXEL Confidential
keep_alive
106
30000