ZyXEL Communications VMG1312 Cli Reference Manual page 6

www.zyxel.com
COMMANDS
start:
Starts the Broadcom ADSL driver. This command calls BcmAdsl_Initialize to initialize the driver and
BcmAdsl_ConnectionStart to start ADSL PHY connection if [--up] is specified. This command takes
parameters that can specify various connection modes. These parameters are the same as in "configure"
command.
stop:
Stops ADSL connection and Broadcom ADSL driver. This command calls BcmAdsl_Uninitialize.
configure :
Configures ADSL connection parameters. These command takes the same parameters as "start"
command except for [--up] . This command will cause ADSL PHY to retrain.
connection :
Controls ADSL connection modes, such as up and down and several special test modes. This
command can also be used to specify tone selection for upstream and downstream..
bert :
Controls ADSL bit error rate test (BERT). This command can start/stop
the BERT test and monitor its results.
afelb :
Starts, sets control parameters such as test time, signal type for AFE loopback test.
qlnmntr :
Starts, sets control parameters such as total monitor time,reporting frequency for QLN monitoring test
mode.
inm :
To configure inm parameters and Start inm, Stop monitoring, and show inm results
info :
Display information about ADSL driver and PHY status.
diag :
Log statuses locally. It is useful when DslDiags is not available
snrclamp :
Command to configure shape of snrclamping mask.
info :
About the adsl link information.
nlnm :
ZyXEL Confidential
6