Chapter 7 Maintenance/Storage; Tv Antenna; Lubricating The Elevating Gear (Fig. 7-1); Lubricating The Bearing Surface (Fig. 7-2) - Jayco 2004 Talon ZX Owner's Manual

Table of Contents

Advertisement

Your new Jayco sport utility trailer is designed to be as maintenance free as possible. However,
maintenance is important to retain its condition as near new as possible. Proper maintenance will
give you many trouble-free miles.
NOTE: Some areas in this chapter may not be applicable to your sport utility trailer.

TV ANTENNA

Lubricating the Elevating Gear (Fig. 7-1)

The elevating gear will need to be lubricated with a liberal amount
of silicone spray. To lubricate, apply the silicone to the elevating
gear with the lift in the down position then run the lift up and down
a few times to distribute the lubricant over the gears.

Lubricating the Bearing Surface (Fig. 7-2)

Twice per year or when rotation of the antenna becomes
difficult, lubricate the bearing surface between the rotating
gear housing and the base plate with silicone spray. Elevate
the antenna and remove the set screw or plastic plug from
the rotating gear housing. Spray the silicone into the hole
and around the edges of the gear housing. Rotate the gear
housing until the lubricant coats the bearing surface and the
antenna rotates freely.

Lubricating the Rubber Quad Ring (Fig. 7-3)

Lubricate the rubber quad ring located on the elevating shaft below
the worm gear with silicone spray at least twice per year to prevent the
quad ring from becoming brittle resulting in leaks in the elevating shaft.
Refer to the vendor's owner's manual for information regarding removal of
the worm gear assembly.

TOILETS

Aqua Magic® 4
The Aqua Magic 4 does not require routine maintenance except for cleaning. In some installations
the seat and cover can be removed to facilitate cleaning. To remove seat, both seat and cover should
be in the open (up) position. Grasp assembly on both sides and pull away from you in an upward
angle of approximately 45°. To reinstall seat and cover, place legs of assembly in rear slots of cover
until they are centered on hinge posts and gently push down at approximately 45° until you feel the
engagement.
96
Chapter 7
MAINTENANCE/STORAGE
Lubricate Here Fig. 7-1
Fig. 7-2
Spray
Remove Plastic
Around
Plug and spray
Edges
lubricant into hole
Fig. 7-3
Wave
Washer
Flat
Washer
Rubber
Ring

Talon Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Talon zx

Table of Contents