How To Operate Your Radio; To Receive; To Transmit; Battery Installation - Jayco 2004 Talon ZX Owner's Manual

How to Operate your Radio

TO RECEIVE:

1. Turn the power "On".
2. If the "Battery Low" indicator is on, charge the batteries.
3. Set the channel selector to the desired channel.
4. Adjust the volume control to a desirable listening level by
pressing and holding the monitor button while turning the
volume control knob.

TO TRANSMIT:

1. Turn the power to "On".
2. If the "Battery Low" indicator is on, charge the batteries.
3. Set the channel selector to the desired channel.
4. To transmit, press the Push to Talk button. Speak slowly
and clearly in a normal voice, approximately 2-3 inches
form the microphone. A built-in modulation control
circuit will automatically adjust the microphone input
level. Ther is no need to speak loudly.
5. To receive, release the Push to Talk button.

Battery Installation

Your radio comes with four nickel cadmium cells. Remove the cover by releasing the clasp at the
bottom of the compartment. Observe the polarity symbols insid eth ebattery tray when installing
new batteries. Do not install different types of batteries (standard, alkaline, or different brand
rechageable).
I
CAUTION: Incorrect battery installation can damage the unit.

Battery Saver Mode

Your Two Way Radio has a unique circuit designed to dramatically extend the life of your batteries.
Four seconds after the transmit button has been pressed, the radio will switch to battery saver mode,
and the LCD display will turn off. The transceiver will remian ready to treceive any incoming
transmissions while in the battery saver mode. Pressing any of the buttons will illuminate the
display and exit the battery saver mode.
Appliances 91