Refrigerator Storage; Refrigerator Maintenance; Refrigerator Fuse Replacement - Jayco 2004 Talon ZX Owner's Manual

Refrigerator Storage

Before the refrigerator is stored for an extended (seasonal) period of time:
• Remove the black AC power cord from the receptacle and disconnect the DC power wires of
the refrigerator.
• Defrost and clean the interior of the refrigerator.
• Close the doors with the storage latch.
If the refrigerator is stored for an extended period of time, before ignition or start up:
• Make sure there are no obstructions in the burner, the orifice, or the flue.

Refrigerator Maintenance

GAS FLAME APPEARANCE:
While in GAS operation, examine the appearance of the gas flame:
• Turn the temperature switch to the COLDEST position.
• Open the lower intake vent.
I
CAUTION: The burner box cover can be hot. Wear gloves to avoid burns.
• Open the burner box door and look at the gas flame.
• The flame should be a darker blue inside and a lighter blue outside and should be a
constant and steady shape.
• If the flame is yellow or has an erratic and unstable shape, contact your dealer or Norcold
authorized service center.
• Make sure the flame does not touch the inside of the flue tube.
• If the flame touches the inside of the flue tube, contact your dealer or Norcold authorized
service center.
• Close the burner box door.

Refrigerator Fuse Replacement

The electrical circuits of this refrigerator have fuses to protect them from an overload. If a fuse is
unserviceable, replace it as follows.
I
WARNING: Do not operate the refrigerator without the power board cover on the
refrigerator. To prevent a circuit overload and a possible electrical fire, use only these
fuses:
DC control circuit
AC circuit
1. Push the selector switch to the OFF position to shut down the refrigerator.
2. Remove the black AC power cord from the receptacle.
3. Remove the AC power cord from the power board that is at the rear of the refrigerator.
4. Remove the DC power supply wires from the power board.
5. Remove the ignition sense wire from the power board.
6. Remove the gas valve wires from the power board.
Maintenance/Storage
5 amp tan blade type automotive fuse
5 amp glass cartridge fuse
103