Tv Antenna; Raising Antenna To Operating Position; To Test System; Lowering Antenna To Travel Position - Jayco 2004 Talon ZX Owner's Manual

TV ANTENNA

Raising Antenna to Operating Position

Turn the elevating crank clockwise in the UP direction about thirteen turns or until some resistance
to turning is noted. (Fig. 3-38)
On Amplified models, 12-Volt DC power is required. Turn the power supply ON to use either the
front or rear TV outlet. (Fig. 3-39) Neither outlet will work unless the power supply switch is on.
Turning the power supply on sends 12-volt DC through the cable to the antenna. The voltage
energizes the transistors on the amplifier in the antenna head. The TV signal comes back down the
cable to the outlets.
After the antenna is in the full UP position, pull down on the round knob with both hands until it
disengages from the ceiling plate. Rotate the knob for best picture. (Fig. 3-40)
Fig. 3-38

To Test System

1. Make sure the TV set is working properly.
2. Switch the power supply ON and OFF to see if there is a difference
in the picture quality while watching TV. If there is NO difference, refer to
manufacturer's manual for further testing procedures.
I
CAUTION: The power supply should be turned OFF when connecting/disconnecting the
cables to the power supply and antenna, but should be turned ON when testing for voltage.

Lowering Antenna to Travel Position

Rotate the antenna until the pointer on the directional
handle aligns with the pointer on the ceiling plate. (Fig.
3-41) Turn the elevating crank counterclockwise in the
DOWN direction about thirteen turns or until resistance is
noted. (Fig. 3-38) The antenna is now locked in the travel
position.
I
CAUTION: When lowering the antenna, never lower it into any position except the travel
position. Failure to lower antenna into the travel position before traveling may damage the
antenna and is not covered by warranty.
Use Of Your Sport Utility Trailer
I
WARNING: DO NOT
connect high
devices such
dryers to this receptacle.
Maximum current rating
of this receptacle is 7.5
amps at 12-volt DC.
current
as hair
Fig. 3-39
Fig. 3-40
Fig. 3-41
33