Brakes; Fuel Pump - Jayco 2004 Talon ZX Owner's Manual

Brakes

The electric brakes operate on 12 volt DC power from tow vehicle through blue and white wires on 7
way pigtail and harness. More information on the brakes is found in Chapter #3.

FUEL PUMP

Observe all safety precautions concerning safe handling of petroleum fuels.
TO ENSURE SAFE OPERATION, ALL FUEL TRANSFER SYSTEMS MUST BE
PROPERLY GROUNDED.
component to the next including tank, bung, pump, meter, filter, hose and nozzle. Care should
be taken to ensure proper grounding during initial installation and after any service or repair
procedure.
I
WARNING: For your safety, please take a moment to review the warnings below:
1. To prevent physical injury, observe all precautions against fire or
explosion when dispensing fuel. Do not operate the system in the
presence of any sources of ignition.
2. Observe precautions against electrical shock when operating the
system. Do not operate any electrical equipment in damp or wet
locations.
3. Avoid skin contact with petroleum fuels. Use goggles, gloves, and
aprons and change saturated clothing promptly. Wash fuel off skin
promptly with soap and water.
4. These pumps are designed for use ONLY with gasoline, kerosene, and
diesel fuel. Do NOT use this pump for any other fluids. It could
damage the pump and will void the warranty.
5. Leaving the system running without fluids can damage the pump. If
fuel is not delivered after 15 to 20 seconds, turn the system off and
check for problems.
6. Inspect external pump wiring regularly and make sure it is correctly
attached to the battery. Use extra care when connecting the pump to
power.
7. Do not pump the tank completely dry. Contaminants from the tank
bottom might damage the pump.
8. An automatic bypass valve prevents pressure build up when the pump
is on with the nozzle closed. TO avoid pump damage, do not run the
pump more than 10 minutes with the nozzle closed.
9. After running the pump for a maximum of 30 minutes, allow it to cool
for 30 minutes.
10. ALWAYS DISCONNECT POWER BEFORE REPAIRING OR
SERVICING THE PUMP. NEVER APPLY POWER TO THE
SYSTEM WHEN ANY COVER PLATE IS REMOVED.
11. If cleaning with solvents, observe the solvent manufacturer's
recommendations for safe use and disposal.
58
SAFETY INSTRUCTIONS
This means continuous metal to metal contact from one
Talon Owner's Manual