Fuel Station; Furnace - Jayco 2004 Talon ZX Owner's Manual

FUEL STATION

Clean the inlet strainer after every 40 hours of
operation or if low flow occurs.
TO CLEAN OR REPLACE STRAINER
1. Turn the pump off and disconnect it from
power.
2. Remove the strainer cover plate.
3. Remove the inlet strainer and inspect for
damage or clogs.
4. Clean the strainer with a soft bristled brush
and solvent. If the strainer is very dirty,
compressed air may be used. If damaged,
replace the strainer.
NOTE: A very dirty strainer can indicate a
contaminated fuel tank. Clean the tank
as necessary.
5. Clean the cover plate and O-ring.
6. Coat the O-ring lightly with grease.
7. Place the strainer in the cavity.
8. Ensure the cover plate O-ring is properly seated and tighten the strainer cover plate.
I
CAUTION: If there is any fuel left in the fuel tank when storing the unit, add a gasolene
stabilizer to the tank. Refer to instructions for proper use on the stabilizer bottle.

FURNACE

Preventive maintenance and safety checks should be performed by a qualified technician once a
year, or more, depending on the use of the furnace. Failure to properly maintain the furnace may
void the furnace warranty and can result in unsafe furnace operation. Preventive maintenance is
NOT covered under the warranty. Power should be disconnected before servicing.
NOTE: To increase motor life, the furnace should be wired directly to the battery.
I
WARNING: If the user of this appliance fails to maintain it in the condition in which
it was shipped from the factory or if the appliance is not used solely for its intended
purpose or if appliance is not maintained in accordance with the instructions in this
manual, then the risk of a fire and/or the production of carbon monoxide exists which
can cause personal injury, property damage or loss of life.
98
Gear
Coverplate
Inlet Strainer
O-ring
Strainer
Cover
Fig. 7-4
Talon Owner's Manual