Table of Contents
Advertisement
The BBQ Grill grate is coated with standard grill enamel and can be cleaned as you
would a grill at home. Underneath the grate, there is a heat diffuser. This is formed and
ventilated to distribute the heat from the burner. Do not use lava rocks in this grill.
To disconnect the BBQ grill, turn the temperature control to the "OFF" position. Reverse
the above fuel hose hookup procedures. Wait until the grill is completely cooled, and
then store it in the supplied carrying case. This carrying case will ONLY accommodate a
cool grill. The grill carrying case has a pocket for accessories such as the fuel hose in the
lid. The bracket will not fit inside the carrying case and will need to be stored in a
separate location.
1
CAUTION: The BBQ grill must be COMPLETELY cooled before storing to
avoid damaging the carrying case.
MICROWAVE OVEN / CONVECTION OVEN
The microwave oven or convection oven in the unit operates on the same principle as the
microwave/convection in your kitchen at home. A separate owner's manual is provided
with detailed instructions for its use.
78
CHAPTER 8
MAINTENANCE/STORAGE
Your new Jayco travel trailer is designed to be as maintenance free as possible. However,
maintenance is important to retain its condition as near to new as possible. Proper
maintenance will give you many trouble-free miles.
NOTE:
Some areas in this chapter may not be applicable to your travel trailer.
TOILET MAINTENANCE – AQUA MAGIC
®
The Aqua Magic
4 does not require routine maintenance except for cleaning. In some
installations, the seat and cover can be removed to facilitate cleaning. To remove the seat,
both seat and cover should be in the open (up) position. Grasp the assembly on both sides
and pull it away from you in an upward angle of approximately 45°. To reinstall the seat
and cover, place the legs of the assembly in the rear slots of the cover until they are
centered on hinge posts and gently push it down at approximately 45° angle until you feel
the engagement.
TV ANTENNA
Lubricating the Elevating Gear
The elevating gear will need to be lubricated with a liberal amount of silicone spray. To
lubricate, apply the silicone to the elevating gear with the lift in the down position then
run the lift up and down a few times to distribute the lubricant over the gears.
Lubricating the Bearing Surface
Twice per year or when rotation of the antenna becomes difficult, lubricate the bearing
surface between the rotating gear housing and the base plate with silicone spray. Elevate
the antenna and remove the set screw or plastic plug from the rotating gear housing.
Spray the silicone into the hole and around the edges of the gear housing. Rotate the gear
housing until the lubricant coats the bearing surface and the antenna rotates freely.
Lubricating the Rubber Quad Ring
Lubricate the rubber quad ring located on the elevating shaft below the worm gear with
silicone spray at least twice per year to prevent the quad ring from becoming brittle
resulting in leaks in the elevating shaft. Refer to the manufacturer's owner's manual for
information regarding removal of the worm gear assembly.
Lubricate Here
Spray
Around
Edges
Fig. 8-1
®
4
(Fig. 8-1)
(Fig. 8-2)
(Fig. 8-3)
Wave
Washer
Flat
Washer
Remove Plastic
Rubber
Plug and spray
Ring
lubricant into hole
Fig. 8-2
Fig. 8-3
79
Advertisement
Table of Contents
