Patio Canopy And Screen Room (Option) - Jayco 2004 Talon ZX Owner's Manual

Patio Canopy and Screen Room (Option)

Your patio canopy and screen room have been designed and built with quality material to give you
years of trouble free service with low maintenance. Read all instructions completely before
beginning the set up process. One person can do the set up, but two people will make it easier.
Because of the height of the ramp door, you will need a step stool to complete some of the steps.
NOTE: Pole storage bags have been provided.
1. Level the ramp door by attaching the cable at
the ramp door and to the frame of the trailer.
Remove the pin from the bracket and insert the
loop at the end of the cable. Insert the pin
through the cable loop. The length of the cable
can be adjusted to achieve a level plane.
2. Take note that the grey J-molding at the top
edge of the canopy storage bag is facing toward
you and the brass grommets and zipper are
facing away from you. Slide the grey J-molding
of the canopy storage bag into the J-rail
mounted at the top of the ramp door. Center the
canopy over the ramp opening. (Fig. 3-14)
3. Prior to assembling the twist poles, tension rafters and divider pole, become familiar with
each pole, its description and where it belongs.
a. Twist poles – quantity of three (3). (Fig 3-15) (Come already assembled.)
• Two of the three (3) twist poles, will have a metal eyelet at one end and a ball at the other
end. (The ball will be inserted into the socket (Fig. 3-18) mounted on the outer corners
of the ramp.)
• One twist pole will have a white crutch tip with a hanging wire tie down (Fig. 3-19) on
one end and a metal eyelet at the other end.
b. Tension rafters – quantity of three (3) when assembled. (6 pieces in all)
• All 3 tension rafters will have a white crutch tip (without a hanging wire tie down) on
one end and a peg end at the other end when assembled. (Fig 3-16)
c. End divider bar – quantity of one (1) when assembled. (3 pieces in all)
• The end divider bar will have a black rubber end cover on each end and three (3) holes
(one toward each end and one in the middle) when assembled. (See Fig 3-17)
Fig. 3-15
Fig. 3-18
28
Fig. 3-16
Fig. 3-19
Fig. 3-14
Fig. 3-17
Talon Owner's Manual