Canon GP200 Service Manual page 406

5. INSTALLATION
5) If group control is not to be used, go to step
11).
If group control is to be used, set the input
method, control type, and paper size to suit
the needs of the user.
Set bit 3 of the DIP switch (SW5) on the Copy
Data Controller to ON.
LED1 LED2 LED3
SW2
SW3
LED4 LED5 LED6
JC8
JC5
JC6
JC9
CPU
IPC
J5
6 1 6 1
SW1 ON SW5 ON
6 1
SW5-3
Figure 5-513
6) Connect the connector 3 of the Keypad-A1 to
the connector (J3) 4 of the Coy Data
Controller-A1.
4
Figure 5-514
5–38
COPYRIGHT © 1996 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
JA1
JB2
JA2
JB1
SW4
3
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
7) Press the switch (SW2) on the Copy Data
Controller-A1 to start service mode.
SW2
LED1 LED2 LED3
SW2
SW3
LED4 LED5 LED6
JC8
JC5
JC6
JC9
CPU
IPC
J5
6 1 6 1
SW1 ON SW5 ON
Figure 5-515
8) Make settings as follows:
8-1) Select card/ID input using the Keypad-A1.
(Initially, card input.)
8-2) To change from card input to ID input, per-
form the following using the Keypad-A1.
To change from ID input to card input
(requires the Card Reader-A1), go to 8-4).
MANAGE=CARD will be indicated.
8-3) Press the 2 key, and press the
MANAGE=ID will be indicated.
8-4) To change to card input, press the 1 key
after MANAGE=ID has appeared; then, press
the key.
ENT
MANAGE=CARD will appear.
Code Input method
1
2
Table 5-502
JA1
JB2
JA2
JB1
SW4
key.
ENT
Card
ID