Copy Data Controller-A1 - Canon GP200 Service Manual

5. INSTALLATION
V. COPY DATA
CONTROLLER-A1
1) Remove the two screws 2, and remove the
upper cover 1.
1
2
Figure 5-501
Bit Position
SW1 1~3 OFF For normal operation.
4 ON For IPC communication.
OFF For serial communication.
5 ON For using a central control device.
OFF For normal operation or for remote control
using a commercially
available modem.
6 ON For initializing the RAM.
OFF For normal operation.
SW5 1 ON For factory adjustment.
OFF For normal operation.
2 ON For control of Inch-configured papers
(11x17, LTR, LGL, STMT).
OFF For control of AB-configured papers (A3,A4,
B4, B5).
3 ON For service mode.
OFF For normal operation.
4 ON For group control.
OFF For not using group control.
5, 6 OFF Not used.
Note
If the Control Card V is to be used or if remote control only by the Copy Data Controller-A1 is to be
used*, set bit 4 of the DIP switch (SW5) to OFF.
5–34
COPYRIGHT © 1996 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
2) Set the DIP switch (SW1, SW5) on the Copy
Data Controller-A1 to suit the needs of the
user.
2-1) Set the DIP switch (SW1-4) to suit the copi-
er type.
2-2) To use the group control function, set bit 2 of
the DIP switch (SW5) to suit the control paper
2
size.
To use AB-configured papers (A3, A4, B4,
B5), set the bit to OFF.
To use Inch-configured papers (11x17, LTR,
LGL, STMT), set the bit to ON
Function
Table 5-501
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
CLC700/800, NP6750, NP6016, GP
Series
NP6030, NP6060, NP8530, NP9800
Requires the Interface Board-B1.
Requires a commercially available
modem and the Interface Board-
B1 for remote control via a modem.
To select a paper other than indicated,
use service mode.
See 10) of 5. "Checking the Operation."
*1 See Note.