Exposure; Illuminating Assembly - Canon GP200 Service Manual

V. EXPOSURE
A. Illuminating Assembly
1. Removing the Scanning Lamp
Caution:
1. Wait until the surface of the scanning
lamp has cooled before starting the work.
2. Do not leave fingerprints on the surface of
the scanning lamp (in particular, on the
transparent side).
3. If the surface of the scanning lamp is
soiled, dry wipe it.
1) Disconnect the power plug.
2) Remove the copyboard glass.
Figure 4-501
COPYRIGHT © 1996 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
3) Remove the four screws, and remove the rear
4) Remove the feeder unit or the copyboard
5) Disconnect the connector, and disengage the
6) Move the No. 1 mirror mount so that it is as
7) Remove the screw, and remove the fluores-
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
cover.
cover; then, remove the two screws, and
remove the upper rear cover.
hook assembly e; then, remove the scanner
cooling fan.
2
3
Figure 4-503
shown when viewed from the rear.
cent lamp cover r; then, pull out the scan-
ning lamp.
4
Figure 4-504
4–27