Shift Cable Inspection / Adjustment - Polaris RZR XP 1000 2014 Service Manual

w
7. Remove the drain plug
completely.
8. Clean the drain plug magnetic surface.
9. Reinstall the drain plug and torque to specification.
10. Add the recommended amount of fluid through the fill
hole. Maintain the fluid level even with the bottom
threads of the fill plug hole.
FLUID CAPACITY
Recommended Front Gearcase Fluid:
Demand Drive Fluid 2877922 (quart)
Capacity: approx. 8.5 oz (250 mL)
11. Reinstall the fill plug and torque to specification.
TORQUE
Front Gearcase Fill / Drain Plug Torque:
10 ft-lbs (14 Nm)
12. Check for leaks. Dispose of used fluid properly.

SHIFT CABLE INSPECTION / ADJUSTMENT

Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear lash (noise)
• Gear selector moving out of desired range
q
1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
and allow fluid to drain 2. Inspect shift cable, clevis pin, pivot bushings
3. If adjustment is required, loosen the lower jam nut
4. Adjust the shift cable so there is the same amount of
5. Thread the upper or lower jam nut as required to
6. Once the proper adjustment is obtained, place the
7. Start engine and shift through all gears to ensure the
e
dust boot . Replace if worn or damaged.
and pull the cable out of the mount
t
upper jam nut .
cable travel when shifting slightly past HIGH gear
and PARK.
obtain proper cable adjustment.
NOTE
This procedure may require a few attempts to obtain
the proper adjustment.
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount.
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.
MAINTENANCE
r
, and
2
y
w
to move the
2.29