Reversing The Burner Door - Buderus Logano GB125/22 BE Installation And Service Instructions Manual

4.2

Reversing the burner door

The burner door is factory-fitted with the hinges on the
right – the burner door opens to the right. You can change
the burner door hinges over to the left-hand side if
required to suit the installation site.
Requirement: the burner hood must have been removed
first ( Chapter 3.1, page 14).
V Removing the burner door (
V Unscrew the hinge-pin bolts [1] and remove the hinge
pins [2].
V Fix the hinge pins [2] on the left-hand side of the boiler
using the hinge-pin bolts.
V Unscrew the hinge-barrel bolts [1] and remove the
hinge barrels [2].
V Fix the hinge barrels [2] on the left-hand side of the
burner door [3] using the hinge-barrel bolts.
V Hang the burner door [3] by locating the hinge barrels
[2] on the hinge pins [4].
V Check that the heat exchanger baffles are placed hori-
zontally ( Chapter 6.3, page 34).
V Close the burner door [3] and secure with the two hex-
agon-head bolts. Tighten the hexagon-head bolts
evenly (approx. 90 lb ins) so that the burner door seals
properly.
If the burner door hinges have been changed
over to the left-hand side, the burner cable
must be disconnected from the burner before
opening the burner door.
Logano GB125 BE US/CA - Technical specifications are subject to change without prior notice.
Chapter 3.1, page 14).
1 2
Fig. 9 Reversing the burner door (boiler heat
exchanger attachments)
1 Hinge bolts
2 Hinges
3
2
1
4
Fig. 10 Reversing the burner door (door attachments)
1 Hinge-barrel bolts
2 Hinge lobes
3 Burner door
4 Hinges
5 Heat exchanger baffle plates
4
Placing the boiler
2 1
7 747 019 141-08.1RS
5
7 747 019 141-09.1RS
17