Setting The Stroke Movement For The Feeding Foot - DURKOPP ADLER 967 Instruction Manual

Cover
• Arm cover ( p. 11).
• Head cover ( p. 12).
Fig. 43: Aligning the feed stroke of the feet
①
②
③
④
(1) - Presser foot
(2) - Sewing foot
(3) - Plate
Setting steps
1. Put the handwheel into the 0° position ( p. 20).
2. Set stitch length to 0.
3. Adjust the zero stroke of the feet ( p. 59).
4. Loosen the screw (5).
5. Take the plate (3) out of its working position (4), turn it around and place
6. Manually move both feet down as far as they will go.
7. Tighten the screw (5).

11.4 Setting the stroke movement for the feeding foot

62
it under the feet as illustrated so that the sewing foot (2) is 0.3 mm lower
than the presser foot (1).
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Switch the machine off before you check and set
the stroke movement for the feeding foot.
Adjusting the sewing foot feed
(4) - Working position of the plate (3)
(5) - Screw for the lever used to raise the
feet
Service Instructions 967 - 02.0 - 12/2015
⑤