Adjusting The Positioning Of The Machine; Determining The Drive Ratio In The Control Program; Adjusting The Reference Position Of The Handwheel - DURKOPP ADLER 967 Instruction Manual

6.2 Adjusting the positioning of the machine

The machine will stop automatically at two angular positions on the main
shaft (of the handwheel). To ensure that the machine will properly stop at
these positions, you need to set the reference position of the handwheel.
The proper setting of the reference position requires that the drive ratio be-
tween motor and main shaft be input properly into the control program of
the machine.
Fig. 19: Adjusting the positioning of the machine
(1) - OP1000 control panel

6.2.1 Determining the drive ratio in the control program

Setting steps
1. Select parameter setting mode on the OP1000 control panel (1) and set
2. Manually rotate the handwheel (2) by at least 2 turns.
 The display on the control panel will show a new value for the drive
3. Press the OK key to acknowledge this new parameter value.

6.2.2 Adjusting the reference position of the handwheel

Proper setting
The reference position is at 105° on the handwheel scale (2).
Setting steps
1. Select parameter setting mode on the OP1000 control panel (1) and set
28
the parameter t 08 19 ( DAC basic/classic Service Instructions).
ratio.
the parameter t 08 10 ( DAC basic/classic Service Instructions).
Setting the drive
①
②
(2) - Handwheel
Service Instructions 967 - 02.0 - 12/2015