Safety; Basic Safety Instructions - DURKOPP ADLER 967 Instruction Manual

Safety

2
This chapter contains basic information for your safety. Read the instruc-
tions carefully before setting up or operating the machine. Make sure to
follow the information included in this section. Failure to do so can result
in serious injury and property damage.

2.1 Basic safety instructions

The machine may only be used as described in these instructions.
The instructions should be available at the machine's location at all times.
Work on live components and equipment is prohibited. Exceptions are de-
fined in the DIN VDE 0105.
For the following work, the machine must be disconnected from the power
supply using the main switch or by disconnecting the power plug:
Missing or faulty spare parts could impair safety and damage the machine.
Make sure you only use original replacement parts from the manufacturer.
Use a sturdy lifting carriage or stacker for transporting the machine. Raise
Transport
the machine max. 20 mm and secure it against slipping off.
The power cable must have a plug authorized for the country in which the
Setup
machine is being used. The power plug may only be connected to the
power cable by qualified specialists.
Observe the country-specific safety and accident prevention regulations
Obligations
of the operator
and the legal regulations concerning industrial safety and the protection of
the environment.
All warnings and safety signs on the machine must always be in legible
condition and may not be removed. Missing or damaged labels should be
replaced immediately.
The machine may only be set up by qualified specialists.
Requirements to
be met by the
personnel Maintenance work and repairs may only be carried out by qualified
specialists.
Work on electrical equipment may only be carried out by qualified specialists.
Only authorized persons may work on the machine. Every person who
works on the machine must first have understood these instructions.
Service Instructions 967 - 02.0 - 12/2015
Safety
• Replacing the needle or other sewing tools
• Leaving the workplace
• Performing maintenance work and repairs
• Threading
5