Setting The Stroke Movement - DURKOPP ADLER 967 Instruction Manual

Fig. 30: Setting the height of the feed dog
①
(1) - Feed dog carrier
Setting steps
1. Place the feed dog at top dead center.
2. Loosen the setscrews (2).
3. Push the feed dog carrier (1) up until the upper edge of the feed dog
4. Tighten the setscrews (2).

8.2.3 Setting the stroke movement

Sequence
First check the following setting:
• Feed dog height ( p. 43)
Proper setting
The upper edge of the feed dog must be the same height when the feed
dog is at front dead center (handwheel position 90°) as when it is at rear
dead center (handwheel position 270°).
At 90°, the feed dog is moving upwards,
at 270°, it is moving downwards.
44
protrudes 1.3 mm above the throat plate.
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch the machine off before you check and set
the stroke movement of the feed dog.
Setting the feed dog
(2) - Setscrew
Service Instructions 967 - 02.0 - 12/2015
②