Aligning The Feed Stroke Of The Feet - DURKOPP ADLER 967 Instruction Manual

Adjusting the sewing foot feed
Fig. 42: Adjusting the presser foot bar drive dog
①
②
③
④
⑤
⑥
⑦
(1) - Screw
(2) - Pin
(3) - Screws
(4) - Shaft
(5) - Gully
(6) - Assembly
(7) - Plate
(8) - Presser foot
Setting steps
1. Put the handwheel into the 0° position ( p. 20).
2. Set stitch length to 0.
3. Loosen the screws (3).
4. Loosen the screw (1).
5. Take off the assembly (6) along with the shaft (4) and the pin (2).
6. Loosen the drive dog screw (14).
7. Take out the plate (7) and insert it under the feet with the smooth surface
8. Insert the needle shaft into the opening (11), turn the lever (13) such
9. Tighten the drive dog screw (14).
10.Refit the assembly (6). Make sure there is an axial play of 0.2 to 0.3

11.3 Aligning the feed stroke of the feet

The main purpose of this adjustment is to ensure that, at the start of feed-
ing, the presser foot is lifted above the material and the material feeding
movement is not prevented by the sewing foot.
Proper setting
When the stitch length is set to 0 and the stroke of the foot is set to 0:
 The lever is attached to the lift bar of the feet by the screw (5) in such
Service Instructions 967 - 02.0 - 12/2015
facing up.
that the needle shaft touches the presser foot bar (10) while, at the same
time, pressing both feet (8) and (9) onto the plate (7).
mm between the slide nut (12) and the floor of the gully (5).
a way that the presser foot (1) is positioned 0.3 mm higher than the
sewing foot (2).
(9) - Sewing foot
(10) - Presser foot bar
(11) - Opening for the needle shaft
(12) - Slide nut
(13) - Lever
(14) - Drive dog screw
(15) - Drive dog
⑮
⑭
⑬
⑫
⑪
⑩
⑨
⑧
⑦
61