NETGEAR FS728TP Software Administration Manual page 18

FS728TP Smart Switch Software Administration Manual
Figure 1-3
7. Select Disable to disable DHCP.
8. The default IP address is 192.168.0.239 and the default subnet mask is 255.255.255.0. If you
want different values, enter the switch IP address, gateway IP address and subnet mask.
9. Type your password and click Set. Please ensure that your PC and the FS728TP 10/100 PoE
Smart Switch with Gigabit Ports are in the same subnet. Note the settings for later use.
NIC Setting on the Host that Accesses the FS728TP 10/100 PoE
Smart Switch with Gigabit Ports
The settings of your Network Interface Card (NIC) under MS Windows OS are made with entries
into Windows screens similar to the ones shown below. For comparison, the settings screens of the
switch are also shown although they do not appear in the Windows view.
1-6 Getting Started with Switch Management
v1.1, September 2009