FS728TP Smart Switch Software Administration Manual
Figure 4-18
The Advanced STP Configuration screen contains the following fields:
STP Configuration
•
Spanning Tree State – Select the STP state on the device. The possible field values are:
–
Disable – Disables STP on the device.
–
Enable – Enables STP on the device. This is the default value.
•
STP Operation Mode – Select the STP mode on the device. The possible field values are:
–
STP – Enables STP on the device.
–
RSTP – Enables Rapid STP on the device. This is the default value.
–
MSTP – Enables Multiple STP on the device.
•
Configuration Name – Enter the user-defined configuration name. The maximum length
is 32 characters.
•
Configuration Revision Level – Defines an unsigned 16-bit number that identifies the
revision of the current STP configuration. The revision number is required as part of the
STP configuration. The possible field range is 0-65535.
Configuring Switching Settings
v1.1, September 2009
4-29