FS728TP Smart Switch Software Administration Manual
–
Up – Indicates the LAG is currently linked and forwarding traffic.
–
Down – Indicates the LAG is currently not linked.
•
Reactivate Suspended – Select the action to apply to a suspended LAG. The possible
field values are:
–
Enable – Reactivates the suspended LAG.
–
Disable – Does not reactivate the suspended LAG.
•
Type – Displays the LAG type. The possible field values are:
–
Static – Indicates the LAG is configured manually.
–
LACP – Indicates the LAG is configured automatically.
•
Speed – Select the data transmission rate for the LAG. The LAG type determines what
speed setting options are available. The possible field values are:
–
10M – Indicates the LAG is currently operating at 10 Mbps.
–
100M – Indicates the LAG is currently operating at 100 Mbps.
–
1000M – Indicates the LAG is currently operating at 1000 Mbps.
•
Duplex Mode – Displays the duplex mode of the LAG. The possible field values are:
–
Full – Indicates the interface supports transmission between the device and its link
partner in both directions simultaneously.
–
None – Indicates Duplex mode is not enabled on the LAG.
•
Auto Negotiation – Select the auto negotiation status of the LAG. Auto Negotiation is a
protocol between two link partners that enables a port to advertise its transmission rate and
flow control abilities to its partner. Auto Negotiation is enabled by default. The possible
field values are:
–
Enable – Enables auto negotiation.
–
Disable – Disables auto negotiation.
•
Flow Control – Select the flow control status of the LAG. Operates when the LAG is in
full duplex mode. Flow Control is disabled by default. The possible field values are:
–
Enable – Enables flow control.
–
Disable – Disables flow control.
2. Select the interface.
3. Enter or modify the fields in the first row.
4-6
v1.1, September 2009
Configuring Switching Settings