ESI ESI2000 Operation Manual page 98

Tip: The cursor buttons can be used to
go back to the previous field.
90
ESI Operation Manual
The setup screen is used to select the SCSI ID of the attached Emax II
SCSI device. The SCSI ID may be selected by using the INC/DEC
buttons, or by typing the digit (1-7) directly using the keypad. The
default choice, "Search", instructs the ESI to search for the first Emax II
device in the SCSI chain. Normally you will always use "Search" unless
you want to select a specific Emax II device out of several on the SCSI
bus. Press ENTER to confirm your choice and return to the option select
screen.
5. Press 1 to select the Import Options screen. The following screen
will appear. When this function is set to YES, the ESI will issue an
extra prompt whenever a load operation is about to destroy the
current bank. Press ENTER after selecting your choice.
Confirm new bank: Y/N
6. Press 2 to select the Emax II Load screen. Immediately after Load
is selected, the ESI will attempt to read and verify the Emax II disk
using Search mode or using the SCSI ID selected in the SCSI Setup
screen.
EMAX II LOAD from
B01 Bosendorf8M
If an Emax II disk cannot be found, an error message will be generated
indicating: "No Emax Drive Found".
7. Use the INC/DEC buttons or the Data Entry Control to select
the bank to load. When the correct bank is displayed, press EN-
TER. The following screen will appear:
EMAX II LOAD from
B01 Bosendorf8M
*** ALL PRESETS ***
EMAX II IMPORT
Select Bank
Select Preset