ESI ESI2000 Operation Manual page 47

VCA Attack:
Hold:
Decay:
Sus:50%
Move the cursor under the various envelope parameters and observe
how different settings affect the sound. Before moving on, make sure you
have a sound that is fairly sustained with little or no envelope attack
time.
Other Dynamic Processing Options
1. Select Dynamic Setup (1). Note how the tuning, delay, and chorus
controls affect the sound.
2. Add some Low Frequency Oscillator effects. Select the LFO
function (4). The display shows:
Rate:
Shape:
Delay:
If the LFO rate is different, change the rate so that it is about 4.25 Hz.
3. Use the right cursor/page button to move to the next page of the
LFO controls. The display will show something like this:
Variation:
LFO->Pitch:
LFO->Cutoff
Position the cursor under each display option. Vary the Data Entry
Control and observe how this affects the sound. Adding LFO to Cutoff
might not sound all that noticeable. If you want a more obvious effect,
bounce back to function 3. VCF and set the Cutoff to about 200 Hz and
Q to about 50. This should make the LFOs effect more noticeable.
4. Select page three of the LFO controls. The display will show:
0.20s
0.00s
0.30s
Rel:0.60s
LFO
4.25Hz
triangle
0.00s
LFO
0%
0%
0%
39
Guided Tours