Mount Drives; Rename Disk Bank - ESI ESI2000 Operation Manual

Tip: Use the "Mount Drives" utility
whenever an external SCSI device does not
appear in the list of available devices.
62
ESI Operation Manual

1. Mount Drives

This utility instructs the ESI to check the SCSI bus for the presence of
SCSI devices.
If a SCSI device has been powered up after the ESI, it will not appear in
the list of available devices. The Mount Drives utility tells the ESI to
check the SCSI bus and to add any SCSI devices that it finds to its list of
available SCSI devices. Normally, if the external devices are powered up
before the ESI, this will be done automatically.
1. Activate Master/Global module.
2. Select Disk Utilities (7), 1. Mount Drives (1).
3. The ESI will mount the drives, then return to the Module
Identifier.
Mounting Drives...

2. Rename Disk Bank

This function allows you to name your hard disk banks.
1. Activate Master/Global module.
2. Select Disk Utilities (7), Rename Disk Bank (2).
3. Select an installed drive, then press ENTER.
RENAME DISK BANK
D1
B01 12 String
4. Select the bank to be renamed, then press ENTER.
5. Rename the bank. Choose the characters to be changed with the
left and right cursor buttons. Select the desired characters by using
the ten key pad, Data Entry Control and keyboard. You can also use
the up cursor to insert spaces and the down cursor to delete spaces.
RENAME DISK BANK
D1
B01 12 String
[0-9]/Encoder/Kybd
6. Press ENTER to exit the submodule. The ESI will return to the
Module Identifier.
MOUNT DRIVES
QUANTUM LP1055
Select a Drive
QUANTUM LP1055