ESI ESI2000 Operation Manual page 134

126
ESI Operation Manual
1. Activate Digital Processing module.
2. Select Copy Region (4).
3. Select the sample that you want to copy a section from, then
press ENTER.
COPY REGION from
001 Selected Sample
Select a Sample
4. If the sample is stereo, the following screen will appear. Select
the right side, left side, or both sides (stereo), then press
ENTER. Otherwise, proceed to the next step.
COPY REGION from
001 Selected Sample
Side: Stereo
Select L/R/Stereo
5. Specify the start point on line two and end point on line three
for the portion of the sample to be copied, then press ENTER.
Use the up and down cursor to choose the appropriate line. The size
of the portion to be copied on line four will change to reflect
changes in the start and end points. Pressing ENTER saves the
selected portion in the clipboard. Copying does not affect the
original sample. The clipboard will retain this data until replaced by
something else to be copied, cut, or backed up.
COPY
Start: 0.00
End:
Size:
secs samples
00001
1.61 57881
1.61 57881