Select Zone - ESI ESI2000 Operation Manual

0. Select
Zone
!
Caution: If a zone contains more than one
sample, the new original key will be
assigned to all samples in the selected zone.
196
ESI Operation Manual
This submodule lets you specify the keyboard zone to be processed.
1. Activate Dynamic Processing module.
2. Select Submodule Select Zone (0).
3. If there are both primary and secondary samples assigned to the
preset, select whether the zone will contain both samples, just
the primary, or just the secondary. Press ENTER. If the preset
contains only primary or secondary samples, the ESI will bypass this
screen and proceed immediately to step 4.
P00 both
Select pri/sec/both
4. Select the lowest key of the zone and press ENTER. The default
is the lowest note of the lowest sample. You can select a different low
key in two ways. The Data Entry Control scrolls through the lowest
key of each sample on the keyboard. (The Data Entry Control is the
fastest selection method if you want the lowest key of the zone to
coincide with the lowest note of a sample.) Or, you can use the
keyboard to specify any note as the lowest note of the zone.
P00 both C#1
The second line shows the note being played on the keyboard (or
scrolled with the Data Entry Control). After selecting a note, the third
line will display the primary sample number, and the fourth line will
display the secondary sample number associated with the note on line
two.
5. Select the highest key of the zone and press ENTER. The default
is the highest note of the sample that contains the previously speci-
fied low note. You can select a different high key in two ways. The
Data Entry Control scrolls through the highest key of each sample
on the keyboard. (The Data Entry Control is the fastest selection
method if you want the highest key of the zone to coincide with the
highest note of a sample.) Or, you can use the keyboard to specify
any note as the highest note of the zone.
P00 both C#1 to C#5
Select High Key

SELECT ZONE

SELECT ZONE
Select Low Key
SELECT ZONE