Midi Load Bank; Midi Volume Pedal - ESI ESI2000 Operation Manual

3. MIDI Load Bank

This feature allows a MIDI command to load banks from the hard disk.
The "Magic Preset" is a preset number which tells the ESI that the next
preset change command that it receives over MIDI is the bank number
to be loaded. Therefore, to load a hard disk bank over MIDI, two pro-
gram change commands must be sent, the Magic Preset and the bank
number. For example, if the Magic Preset is set at "085", and the ESI
receives a preset change command of 085 followed by a preset change
command of 011, the ESI will load bank 011 from the hard disk. If
multiple SCSI drives are connected, the ESI will load from the drive
most recently accessed. The Magic Preset is user definable and can be
turned off or set to any preset number from 000 to 127. MIDI Load
Bank always works, regardless of MIDI Global settings.
1. Activate Master/Global module.
2. Select MIDI (9), MIDI Load Bank (3).
Magic Preset:
--- Off
3. Select the Magic Preset or Off to disable MIDI Load Bank.
4. Press ENTER to exit the submodule. The changes will be stored
and the ESI will return to the Module Identifier.

4. MIDI Volume Pedal

This command overrides any footpedal assignments made in the Preset
Definition, Realtime Controllers submodule and forces the footpedal to
become a volume pedal (emulating the front panel volume knob).
Volume Pedal Global Override can be turned On or Off (default is Off).
This setting is stored as part of the System Software and will remain in
its setting after the ESI is powered down and re-booted.
1. Activate Master/Global module.
2. Select MIDI (9), Volume Pedal (4)
Global Override: off
3. Select whether volume pedal global override is on or off.
4. Press ENTER to exit the submodule. The changes will be stored
and the ESI will return to the Module Identifier.
MIDI LOAD BANK
VOLUME PEDAL
81
Master/Global