NEC UNIVERGE NEAX 2000 IPS Reference Manual page 173

Automatic Idle Return
This feature returns a station to the idle state after
3 seconds of reorder tone is received due to the
distant end disconnecting.
Called Station Status Display
This feature provides a display on the status of a
called station on the LCD of the calling Multiline
Terminal.
Calling Name and Number Display
This feature provides a display on the LCD of the
Multiline Terminal receiving a call, indicating the
station number/trunk number of the incoming call.
Group Feature Key
A station user can monitor the status of group
member stations such as idle, busy, hold and
ringing by lamp indication of the multiple line keys.
If a line is idle, a station user can make a call to
the member station by pressing the associated
line key (instead of pressing DSS key). If a line is
ringing or is on hold, a station user can pick up the
incoming call or the call on hold by using My Line,
and the ringing or held line is made idle.
Dynamic Dial Pad
This feature allows a user to make an outgoing
call by first pressing a key on the keypad of
Multiline Terminal without pressing the Speaker
key or going off-hook.
Handsfree Unit
The built-in Handsfree Unit enables full Handsfree
operation for both internal and external calls (No
optional Handsfree Unit is required).
I-Hold / I-Use Indication
Multiline Terminals provide indication of which line
keys have been placed on Hold, or are in use by
that Multiline Terminal. The LED associated with
the line key will give the appropriate indication.
Microphone Control
All Multiline Terminals are equipped with a
Microphone Control button with an associated
LED.
Multiple Line Operation
This feature allows for the appearance of multiple
lines on the Flexible Line Keys and feature keys of
all Multiline Terminals.
UNIVERGE 2000 IPS Request for Proposal (RFP) Reference Guide
NEAX
Issue 6
This feature allows the distant extension user, of a
station user that presses a mute key during
conversation, not to hear the station user's voice
though the station user can hear the distant
extension user's voice. By pressing the mute key
again, the mute status returns to original
conversation.
My Line Number Display
This feature allows the display of the Prime
Extension in the LCD display of the Multiline
Terminal during an Idle state.
Preset Dialing
This feature allows a Multiline Terminal user to
prepare and verify a number in the display on the
LCD before dialing. When a wrong number is
entered, the user can correct the number before
originating the call.
Prime Line Pickup
This feature allows a Multiline Terminal user to go
off hook and originate a call from the line assigned
as the Prime Line without depressing the
associated line key.
Each Multiline Terminal is equipped with a Recall
Key that is used to generate a hookflash to access
features provided by the outside exchange, or to
abandon a call while retaining the line for
origination of another call.
Relay Control Function Key
This feature provides a Multiline Terminal with the
ability to activate/deactivate relays (on a PN-
DK00) to control external devices.
Ring Frequency Control
The ring frequency of the Multiline Terminal can
be controlled on a station basis in system
programming (eight ro fourteen frequencies are
available) or by use of a function key on the
Multiline Terminal.
Ringing Line Pickup
This feature provides the ability to answer any call
ringing into a Multiline Terminal by just lifting the
handset.
Chapter 9 Descriptions
Mute Key
Recall Key
Page 9- 27