Pioneer PRV-LX10 Service Manual page 167

5
How to replace the fan in the ATX Power Supply unit
Removing the fan
1 Remove the switch-barrier fixing screw on the
ATX Power Supply unit (DXF1005) then slide
the switch barrier, as indicated in the figure.
Note:
Be sure to set the POWER switch to OFF and
disconnect the AC power cord from the AC outlet
before starting this step.
2 Remove the fan guard, then remove the fan and
disconnect the harness from the fan connector.
Attaching the fan
1 Connect the harness to the fan connector and
install the fan into the panel. Push the harness
inside.
Notes:
• Place the fan so that the name plate of the fan can be
seen from the front.
• Use the Fan Unit (DZM1001) dedicated to the ATX
Power Supply unit (DXF1005).
2 Attach the fan guard.
3 Slide the switch barrier and tighten the screw.
5
6
ATX Power Supply Unit
(DXF1005)
Switch-barrier fixing screw
Fan Cleaning
Cleaning paper : GED-008
Name plate can be seen.
Hook the slots.
PRV-LX10
6
7
Switch barrier
Remove the fan.
Fan Cleaning
Cleaning paper : GED-008
Push the harness inside so
that it will not come out.
Close.
1. Slide
2. Tighten the screw.
7
8
A
B
Fan connector
C
D
E
F
167
8