Pioneer PRV-LX10 Service Manual page 166

1
10
DC Fan motor (for front Section)
~ Remove the bonnet Assy. (See step ¥)
A
Ÿ Remove the tray panel Section. (See step ø)
! Remove the front panel Section. (See step π)
⁄ Remove the inner cover F. (See step [)
@ Remove the two DRIVE Assy LX1s. (See step ")
¤ Remove the front bridge and heat sink Section. (See step \)
1
Remove the six screws.
1
B
1
1
2
Disconnect the two connectors.
3
Pull up the two fan Sections.
C
4
Remove the two fan Sections.
4
D
PWRB Assy
E
5
Remove the two screws.
Fan duct
Note when replacing the DC fan motor:
Be careful handling the DC fan motor, because even a
light shock to it may result in noise during operation.
F
166
1
2
1
1
1
3 3 3
2
4
2
5
×2
DC fan motor
FAN Cleaning
Cleaning paper (GED-008)
2
3
11
ATX Power supply Unit
~ Remove the bonnet Assy. (See step ¥)
Ÿ Remove the inner cover R. (See step [)
1
Remove the one screw.
2
Remove the four screws.
3
Disconnect the some connectors at need.
4
Remove the ATX Power supply Unit.
2 2
2
2
3
Arrangement of the cables for the ATX Power
supply Unit
PRV-LX10
3
4
ATX Power supply Unit
4
1
ATX Power supply Unit
Wire saddle (8S)
Wire saddle (8S)
Binder
Binder
Cord holder
4