Pioneer PRV-LX10 Service Manual page 165

5
8
PWRB Assy
~ Remove the bonnet Assy. (See step ¥)
Ÿ Remove the tray panel Section. (See step ø)
! Remove the inner cover F. (See step [)
⁄ Remove the two DRIVE Assy LX1s. (See step ")
1
Release the cord holder and the wire saddle.
2
Remove the twenteen screws.
3
Remove the front bridge with the heat sink Section.
Heat sink
2
×2
3
2
2
×2
2
1
Rear view
Front bridge
4
Disconnect the some connectors at need.
5
Remove the three screws.
6
Unhook the two card edge spacers.
7
Remove the PWRB Assy.
Note:
Be careful, because the connector Assy 20P is firmly attached.
5
6
5
7
5
PWRB Assy
5
6
Front bridge
2
×2
2
2
1
×2
2
Heat sink
6
6
7
9
DC Fan motor (for rear Section)
~ Remove the bonnet Assy. (See step ¥)
Ÿ Remove the inner cover R. (See step [)
1
Disconnect the connector Assy 2P.
2
Release the cord holder.
3
Remove the two screws. (Tighten torque : 0.65 N•m)
4
Remove the fan Section.
Note:
When reassembling, dress the wires from the fan so that
they will not touch the fan.
Connector Assy 2P
Fan plate
Fan spacer
Note when replacing the DC fan motor:
Be careful handling the DC fan motor, because even a
light shock to it may result in noise during operation.
PRV-LX10
7
8
2
1
3
4
3
Rear view
Slit
Fan cover
DC fan motor
FAN Cleaning
Cleaning paper (GED-008)
8
A
B
C
D
E
F
165