Key Lock Function; On/Off Switch Of The Material Edge Sensor; Automatic Thread Trimming Switch; One-Shot Automatic Stitching Switch - JUKI cp-180 Instruction Manual And Parts List

13. KEY LOCK FUNCTION
In order to prevent the specified data on the number of stitches or the processes (A, B, C and D) to be
changed by mistake, the setting switch can be locked. (Even with the setting keys locked, the pattern to be
sewn and the value on the bobbn thread counter can be changed.)
) After the completon of the settng of data on the number of sttches, etc., turn OFF the power to the ma-
chne once.
2) Turn ON the power swtch whle smultaneously pressng automatc reverse sttchng (for end) swtch 1
and the " + " swtch of number of sttches settng swtch 2 for process A with fingers.
3) Key mark 3 is shown on the control panel. This completes the locking of keys.
(If the key mark is not shown on the control panel, carry out the aforementioned steps 1) through 3) again.)
* To release the keys from the locked state, perform again the steps 1) and 2).
(Once the key mark goes out, the keys are released from the locked state.)
14. ON/OFF SWITCH OF THE mATERIAL EDGE SENSOR
• When the materal edge sensor, whch s optonally avalable, s connected to the control panel, the ON/
OFF swtch of the materal edge sensor becomes effectve.
• If the material edge sensor is specified, the sewing machine will automatically stop running or perform
thread trmmng when the sensor detects the materal edge.
If the material edge sensor is used in combination with the control panel, carefully read the Instruc-
tion manual for the material edge sensor beforehand.
15. AUTOmATIC THREAD TRImmING SWITCH
• Ths swtch s used to automatcally actuate the thread trmmer n a process where the sewng machne
automatcally stops or when the materal edge sensor s used.
(If the automatic reverse stitching (for end) is specified, the thread trimmer will actuate after the sewing
machne completes the automatc reverse sttchng (for end).)
16. ONE-SHOT AUTOmATIC STITCHING SWITCH
• Ths swtch s used, n the constant-dmenson sttchng mode, rectangular sttchng mode, or n the
process where the material edge sensor is specified, to make the sewing machine automatically perform
sewing at the specified speed until the end of the process is reached only by driving the sewing machine
mode.
1
- 4 -
3
2