Engine Coolant - Ransomes Highway 3 Safety, Operation & Maintenance Manual

8 MAINTENANCE & LUBRICATION

8.4 ENGINE COOLANT ____________________________________________________

Check Engine Coolant Level
(a) The level of coolant in the expansion tank should be
between the MAX and MIN level indicators when
cold.
(b) If topping up is required, remove the plastic cap and
top up using the correct anti-freeze mixture, see
section 8.1.
(c) Replace the plastic cap when finished.
Changing Coolant
(a) To drain coolant, open cock on engine block (A) and
remove hose from radiator (B). Collect coolant using
a suitable container.
(b) Close drain cock on engine block (A) and replace
hose back on to radiator. Ensure all hose clips are
tight.
(c) Refill the cooling system with the correct anti-freeze
mixture, see section 8.1. Fill system through
expansion tank.
(d) The level of coolant in the expansion tank should be
between the MAX and MIN level indicators when
cold.
(e) Run the engine for approximately 5 minutes or until
the thermostat opens.
(f) Check level of coolant in expansion tank and top up if
necessary
Contact With Anti-freeze Can Damage
Your Skin. Use Gloves When Working
With Anti-freeze. If You Come In
Contact With Anti-freeze, Wash It Off
Dispose Of Used Anti-freeze in Accordance With
Local Regulations
en-58
CAUTION
Immediately.
CAUTION
A
B