Slope Warning Screens - Ransomes Highway 3 Safety, Operation & Maintenance Manual

6 CONTROLS
6.2H.7

SLOPE WARNING SCREENS_______________________________________

NOTE
Slope warning screens will only appear when TST is
installed.
During work if the machine is driven onto a slope of 16º
the screen will display this warning which over rides all
other information, and will continue until the machine has
been driven to an area of less than 16º
If the slope angle reaches 18º the screen will display
this warning indicating that the cutting unit arms are
locked in the lower position. An audible warning will
also be given, the buzzer will sound four times every 4
seconds and the red LED's will flash four times every 4
seconds. This will continue until the machine has been
driven to an area of less than 15º.
If the slope angle reaches 22º the screen will display
this warning indicating that at 22deg the centre and
upper unit will be raised 4"-6" above the ground to
improve stability and all units will stop rotating. An
audible warning will also be given, the buzzer will
sound four times every 4 seconds and the red LED's
will flash four times every 4 seconds. This will continue
until the machine has been driven to an area of less
than 16º.
en-32
16°
15
18°
15
22°
15