Cutting Unit Specification; Recommended Lubricants; Cutting Performance (Area) - Ransomes Highway 3 Safety, Operation & Maintenance Manual

4 SPECIFICATION

4.6 CUTTING UNIT SPECIFICATION __________________________________________

Construction
Reel Length
Number of Knives
Reel Diameter (New)
Minimum Reel Diameter (Before Replacement)
Fixed Head Height of Cut (Standard Blade)
Floating Head Height of Cut (Standard Blade)
Floating Head Height of Cut (Thin Blade)
Rear Roll
Height of Cut Adjustment
Transmission
Maximum Reel Speed at Maximum Engine rpm
NOTE
These cutting units are designed to cut grass of maximum height 100mm down to the available height of cut
range.

4.7 RECOMMENDED LUBRICANTS __________________________________________

Engine oil: Should be to MIL-L-2104C or to A.P.I. Classification CD grades. [10W-30]
Hydraulic Oil: ISO VG 46.
Grease: K NATE (RJL No. 4213860), or equivalent to MIL-G-23549C, MIL-G-2345C, DIN 51 825,
DIN 51 818

4.8 CUTTING PERFORMANCE (AREA) _______________________________________

2.5 hectares/hr. at 12 km/hr.
10% allowance is included for normal overlaps and turning at the end of each cut.
en-14
TEMPERATURE
Above 25°C (77°F)
0°C to 25°C (32°F to 77°F)
Below 0°C (32°F)
Sport 200 Sport 200
Heavy duty welded pressed steel construction
762mm 762mm
4
197mm 197mm
178mm 178mm
12.7mm - 89mm
12.7mm - 35.7mm
9mm - 32mm
76mm Diameter
Adjustable screw system on rear roll
By direct drive through splined hydraulic motor to
splined reel.
1240rpm
VISCOSITY
SAE30 or
SAE10W-30 or SAE10W-40
SAE20 or
SAE10W-30 or SAE10W-40
SAE10W or
SAE10W-30 or SAE10W-40
Sport 200
762mm
6 8
197mm
178mm