Changing The Handsfree/Receiver Volume - Gigaset dx800a Instruction Manual

Hide thumbs Also See for dx800a:
Table of Contents

Advertisement

Setting up the base
Activating/deactivating the info
ticker
You can display text information from the
Internet (weather information etc.) that is set
for the screensaver Info Services alterna-
tively as a scrolling message in the idle dis-
play. The scrolling message is shown in the
bottom line of the idle display (immediately
above the display keys). The end of one set
of information and beginning of the next are
separated by "+++".
If, for example, you have set the calendar to
be shown in the idle display, the information
ticker overwrites the last two lines (weeks) of
the calendar.
¢
Ï Settings
¢
v
¢
Info Ticker (³= on)
The ticker starts as soon as the telephone
changes to idle status. If, however, a mes-
sage is shown in the idle display, the infor-
mation ticker is not displayed.
Setting the brightness and time
control for the display backlight
You can set the brightness of the display on
your base and specify a timeframe during
which the display is completely deactivated
e.g., at night.
If the display backlight is deactivated, it can
be reactivated by pressing any key or by an
incoming call. The display backlight is deac-
tivated again after approx. 30 seconds after
the last press of a key.
¢
Ï Settings
¢
v
¢
Backlight
The current setting is displayed.
¤
You can enter data in the following fields:
Time Control
Prerequisite: The date and time have
already been set.
Select On or Off.
The following fields are displayed when
Time Control = On.
112
Display
Display
Display off from:
Enter the time in 4-digit format when the
backlight should be deactivated in idle
mode.
Display off until:
Enter the time in 4-digit format when the
backlight should be reactivated.
Brightness:
Set the brightness of the display back-
light with r.
You can select from five brightness levels
(1 = low – 5 = very bright; e.g., brightness
level 3 = Š).
¤
Press the display key
Changing the handsfree/
receiver volume
You can set the handsfree volume and the
receiver volume, as well as the volume of a
connected wire-bound headset to five dif-
ferent levels.
In idle status
¢
Ï Settings
¢
v
¢
Call Volume
You will hear a test tone.
r
Set the receiver volume.
s
Scroll to the Speaker: line.
r
Set the handsfree volume.
§Save§
Press the display key to save the
setting.
During a call
You can adjust the volume during a call
using the R and S keys. Each time
you press the key, the volume will increase or
decrease by one level.
§Save§
Press the display key if neces-
sary to save the setting perma-
nently.
§Save§
.
Audio Settings

Advertisement

Table of Contents
loading

Table of Contents