Changing The Name Of An Internal Party - Gigaset dx800a Instruction Manual

Connecting/using other devices
External call waiting during an
internal call
If you receive an external call during an
internal call, you will hear the call waiting
tone (short tone). The caller's number or
name appears in the display if Calling Line
Identification is enabled.
You have the following options:
Rejecting the external call
§Reject§
Press the display key.
The call waiting tone is turned off.
You remain connected with the internal
participant.
If the call is via a VoIP connection on the
base: The external caller will hear the busy
tone.
If the call is via the analogue fixed line con-
nection: The call continues to be signalled
on other registered handsets.
Accepting an external call/Putting an
internal party on hold
§Accept§
Press the display key.
You are connected to the external caller.
The internal call is placed on hold.
You have the following options:
u
Swap between both participants:
¤
Use q to swap between the partici-
pants.
u
Speak to both participants at the same
time:
¤
Press the display key
the conference call. Press the display
§EndConf§
key to return to call swap
mode.
Ending an internal call
& / T
Replace the receiver or press the
red end key.
The external call is signalled as an incoming
call on the base. You can accept the call
¢
( page 46).
100
§Conf.§
to establish
Internal call waiting during an
internal/external call
If an internal participant attempts to call you
while you are involved in an external or
internal call, this call is shown on the display
(internal call waiting). You can either accept
or reject this call.
Press any key to make this prompt disappear
from the display.
You must end the current call to accept the
internal call. Then the internal call is sig-
nalled as per usual. You can accept the call.
Changing the name of an
internal party
The names "INT 2", "INT 3" etc. are assigned
automatically at registration. You can
change these names. The name must be no
more than 10 characters. The modified name
will then appear in the list of internal partici-
pants.
u
Open list of internal partici-
pants.
s
Select handset.
§Options§
Open menu.
Rename
~
Enter/edit name.
§Save§
Press the display key.