Table of Contents
Advertisement
First steps
u
By default, the base is assigned the internal name INT 1 and the internal
number 1.
u
The base assigns the lowest free internal number to the handset
(possible numbers: 2–7). The handset's internal name is shown in the display
e.g., INT 2. This means that the handset has been assigned the internal
number 2.
u
You can change the internal numbers and names later
3. Connection wizard
The connection wizard enables you to assign previously configured connections
(fixed line connection, , Gigaset.net and VoIP connections ,
to internal parties as receive and, if applicable, as send connections. Internal parties
are the base, registered handsets, the answering machine for the base as well as any
FAX machine or phone that might be connected
u
Receive connections are numbers (connections) on which you can be called.
Incoming calls are only forwarded to the internal parties (end devices) for which
the relevant connection is assigned as receive connection.
u
Send connections are the numbers that are sent to the called party. The net-
work provider calculates charges based on the send connections. You can assign
each internal party a number or the associated connection as a permanent send
connection.
u
Each connection (number) of your phone can be both a send as well as a receive
connection. You can assign each connection to several internal parties as send
and/or receive connection. It may only be assigned to an answering machine as
a receive connection.
Default assignment
All configured connections are assigned as receive connections to the base, the
registered handsets and the local answering machine 1 at registration/start-up.
When the phone is connected to the analogue fixed line, the devices are assigned
the fixed line number as the send connection.
Starting the connection wizard
a.
Connection Wizard
28
Please note
?
Assign connections
to desk phone
INT 1?
No
¢
(
¤
Press the display key
wish to change the setting for the
send and receive connections of
the base (internal name INT 1).
Yes
¤
Press the display key
not wish to change the setting for
the base.
¢
(
page
98).
page 49
and
page
page
107).
§Yes§
if you
§No§
if you do
20)
Advertisement
Table of Contents
