Assigning Send And Receive Connections To Internal Parties - Gigaset dx800a Instruction Manual

Configuring the system settings
Assigning send and receive
connections to internal
parties
If you have several connections configured
for your telephone system, you can do the
following for each internal party:
u
Assign a send connection or allow the
internal party to select the line for each
external call (select line).
u
Assign one or several receive connec-
tions. Only calls received via one of the
assigned connections are signalled on
the device.
Assigning a send connection
Prerequisite: Several phone numbers are
configured for your base.
¢ Ï Settings ¢
v
¢
Send Connections
~
Enter the system PIN if neces-
sary and press
A list of the internal parties (base, handsets,
device connected to the FAX port INT8 –
where applicable) is displayed.
q
Select the internal parties that
should be assigned a new send
connection and press the dis-
play key
r
Select Select at each call or the
connection that shall be used as
the send connection. All config-
ured connections are displayed
with the names you have set.
Select No outgoing calls to
block all outgoing calls from this
internal party.
Please note
If you select No outgoing calls, all outgo-
ing calls, calls to the network mailbox
and sending of SMS, E-Mail or fax from
this internal party is blocked.
§Save§
Press the display key to save the
changes.
120
Telephony
§OK§
.
§OK§
.
Select at each call is only offered if more
than one connection is configured on the
base.