Changing The Handsfree/Receiver Volume - Gigaset DX800 A User Manual

Setting the brightness and time
control for the display backlight
You can set the brightness of the display on
your base and specify a timeframe during
which the display is completely deactivated
e.g., at night.
If the display backlight is deactivated, it can
be reactivated by pressing any key or by an
incoming call. The display backlight is deac-
tivated again after approx. 30 seconds after
the last press of a key.
¢ ¢
Ï Settings
v
¢
Backlight
The current setting is displayed.
¤
You can enter data in the following fields:
Time Control
Prerequisite: The date and time have
already been set.
Select On or Off.
The following fields are displayed when
Time Control = On.
Display off from:
Enter the time in 4-digit format when the
backlight should be deactivated in idle
mode.
Display off until:
Enter the time in 4-digit format when the
backlight should be reactivated.
Brightness:
Set the brightness of the display back-
light with r.
You can select from five brightness levels
(1 = low – 5 = very bright; e.g., brightness
level 3 = Š).
¤
Press the display key
Display
§Save§
.
Changing the handsfree/
receiver volume
You can set the handsfree volume and the
receiver volume, as well as the volume of a
connected wire-bound headset to five dif-
ferent levels.
In idle status
¢ Ï Settings ¢
v
¢
Call Volume
You will hear a test tone.
r
Set the receiver volume.
s
Scroll to the Speaker: line.
r
Set the handsfree volume.
§Save§
Press the display key to save the
setting.
During a call
You can adjust the volume during a call
using the R and S keys. Each time
you press the key, the volume will increase or
decrease by one level.
§Save§
Press the display key if neces-
sary to save the setting perma-
nently.
Setting up the base
Audio Settings
127