Dc-In Jack - Toshiba Satellite R10 Maintenance Manual

Hide thumbs Also See for Satellite R10:

Table of Contents

4 Replacement Procedures

4.14 DC-IN jack

Removing the DC-IN jack

The following describes the procedure for removing the DC-IN jack. (See Figure 4-23.)

1. Pull up the DC-IN jack straight from the slot of cover assembly.

2. Disconnect the DC-IN jack from the connector CN8800 on the system board

Installing the DC-IN jack

The following describes the procedure for installing the DC-IN jack. (See Figure 4-23.)

1. Connect the DC-IN jack to the connector CN8800 on the system board.

2. Install the DC-IN jack by fitting guide of slot of cover assembly.

Satellite R10 Maintenance Manual (960-509)

Figure 4-23 Removing the DC-IN jack

4.14 DC-IN jack

Table of Contents