Toshiba Satellite R10 Maintenance Manual page 257

4.8 Bottom cover assembly
(6)
Figure 4-11 Removing the bottom cover assembly
Installing the bottom cover assembly
The following describes the procedure for installing the bottom cover assembly. (See
Figure 4-10 and 4-11.)
1. Install the bottom cover assembly to the computer.
Note: Install the bottom cover assembly from the i.LINK (IEEE1394) slot first.
2. Secure the bottom cover assembly with the following screws
M2.0x6.0B
?
M2.0x3.0B
?
3. Turn over the computer and open the display.
4. Connect the touch pad cable to the connector CN3201 on the system board.
4-22
(6)
(6)
(3)
(6)
(6) (6)
(6)
FLAT BIND screw
S-THIN FLAT BIND screw x2 (Described as "3" in figure)
4 Replacement Procedures
(3)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
x19 (Described as "6" in figure)
Satellite R10 Maintenance Manual (960-509)
(6)
(6)
(6)